Install Instructions
Table Of Contents
- About This Manual
- Important Notice
- Introduction
- Document structure
- Document marks
- Key Features
- Hardware Platform
- Power supply
- Lightning protection unit
- Synchronization unit
- // 0) { /* For each inline-commented element clear data-ref and class */ for (var i=0; i < commentedElements.length; i++) { commentedElements[i].dataset.ref= ""; commentedElements[i].className = ""; } } /* Else do nothing */ } }); //]> AUX-ODU-SYNC Mounting
- AUX-ODU-SYNC Cable gland Assembling
- AUX-ODU-SYNC Connection to ODU
- Packing List
- Planning considerations
- Link Pre-configuration in the lab
- Installation
- Operation & Administration
- Troubleshooting
- Glossary
Infinet Wireless: Technical Documentation – InfiMAN Evolution
47 https://wiki.infinetwireless.com/display/DR/Remote+management+of+the+R5000+units
Troubleshooting – 149
•
•
•
•
•
•
•
•
•
•
100 Figure - Switch statistics
8.3.3 Checking the switch settings on the local device
Device management
Make sure that the switch group ID assigned for management on the local device matches with the switch group ID
on the remote device.Make sure that the rf6.0 interface has been added to the switch group. The svi interface must
be associated with the switch group and its IP address is used for the management of the device.For detailed
information about the device management configuration proceed to the"Remote management of the R5000
units
47
" article.
Filtering rules
Pay attention to the traffic filtering rules in the switch group and in the"IPFirewall" subsection.Make sure that the
traffic from the remote device is not restricted.
8.4 The w ireless link thro ughput is lower than expected
Performance tests(see page 149)
Wireless link status(see page 150)
Link statistics on the rf6.0 interface(see page 150)
Radio statistics(see page 151)
QoS statistics(see page 152)
Statistics graphs(see page 152)
Device status(see page 153)
Last reboot reason(see page 153)
System log(see page 153)
Antenna alignment(see page 154)
8.4.1 Performance tests
Web interface
The throughput test can be performed with the "Performance Tests" tool built into the web interface, in the section
"Device status" → "Link statistics for the rf6.0 interface". This tool generates test traffic between the devices and it
allows to obtain data about the real link throughput both in one direction and in a two-way manner. The
throughput evaluation is performed using traffic with the specified priority without taking into account the service
traffic required to maintain the link operational.To exclude the influence of the data traffic on the test's result, it is
recommended to set the highest priority for the test traffic (at least 15).Performance tests are always performed on