Install Instructions

Infinet Wireless: Technical Documentation – InfiMAN Evolution
42 https://wiki.infinetwireless.com/display/DR/svi+command
43 https://wiki.infinetwireless.com/pages/viewpage.action?pageId=10781004
44 https://wiki.infinetwireless.com/display/DR/switch+command
45 https://wiki.infinetwireless.com/pages/viewpage.action?pageId=42274923#mintcommand(TDMAversion)-CurrentConnectionsInformation
46 https://wiki.infinetwireless.com/display/DR/switch+command#switchcommand-Managementcommands
Troubleshooting – 148
•
•
•
98 Figure - Display configuration
8.3.2 Checking the switch settings on the remote device
Device management
Make sure that the switch group for the device management is configured correctly(see point 3 in the figure above):
To access the device via the radio interface, the rf6.0 interface must be added to the management switch
group.
The svi interface must be associated with the switch group. The interface can be associated using the "svi
42
"
command(point 4).
The device's management IP address must be assigned to the svi interface using the "ifconfig
43
"
command(point 1). The switch groups are configured using the "switch
44
" command.
Checking the members of the switch group
To display information about the devices included in the switch groups, use the "mint rf6.0 map swg
45
" command.
99 Figure - Checking the switch group
Switch statistics
To display statistics about the dropped/blocked MAC addresses for each switch group, use the"switch statistics
46
"
command.