Install Instructions

Infinet Wireless: Technical Documentation – InfiMAN Evolution
39 https://wiki.infinetwireless.com/pages/viewpage.action?pageId=10780956
40 https://wiki.infinetwireless.com/pages/viewpage.action?pageId=42274923#mintcommand(TDMAversion)-RemoteCommandManagement
41 https://wiki.infinetwireless.com/pages/viewpage.action?pageId=17597370
Troubleshooting – 147
•
•
•
•
•
•
•
•
•
•
The radio environment analysis is also available via the command line using the "muffer sensor
39
" command.
8.3 The wi reless link is established, but there is no access to the
remote device
Configuration analysis(see page 147)
"Vlan" interfaces(see page 147)
Filtering rules(see page 147)
Checking the switch settings on the remote device(see page 148)
Device management(see page 148)
Checking the members of the switch group(see page 148)
Switch statistics(see page 148)
Checking the switch settings on the local device(see page 149)
Device management(see page 149)
Filtering rules(see page 149)
8.3.1 Configuration analysis
In the web interface go to the section "Device status" → "Link statistics on rf6.0 interface", then left-click on the
device to which the access is missing.Select "Remote commands".
97 Figure - Remote commands
In the pop-up window enter "config show". If the devices are configured via telnet, access to the remote device can
be obtained with the"mint rf6.0 rcmd
40
" command.
"Vlan" interfaces
Make sure that the "vlan" interfaces are configured in accordance with the company's security policy(see point 1 in
the figure below). The VLAN configuration process using the command line is described in the"VLAN
configuration
41
" article.
Filtering rules
Pay attention to the traffic filtering rules in the switch group and in the"IP Firewall menu (see page 118)"
subsection(point 2).