Install Instructions

Infinet Wireless: Technical Documentation – InfiMAN Evolution
36 ftp://ftp.infinetwireless.com/pub/Firmware
37 https://wiki.infinetwireless.com/display/DR/General+Purpose+Command+Set#GeneralPurposeCommandSet-flashnet
Troubleshooting – 145
•
•
If the status of the interface is "Down", enable the radio interface in the "Network settings" section by clicking the
checkbox.
93 Figure - Changing the interface status
If the device does not have a radio interface, the reason for such behavior can be the recovery mode present during
the reset of the device using theERConsole(see page 156).Complete the recovery process by returning the device to
the factory settings from the Maintenance section.
Pay attention to the red values of the parameters in the interface statistics "Mode" column:
Operating frequency - red value of this parameter indicates an absence of data transmission due to the
spectrum scanning by the DFS tool;
TX Power - red value for this parameter may indicate a problem with the transceiver's hardware.
Checking the firmware version
Web interface
In the "Maintenance(see page 129)" section, make sure that the same software version is installed on both device.We
recommend to update the devices to the latest beta software version.
94 Figure - Checking the firmware version
The latest software versions can be downloaded from the official InfinetFTP server
36
.
Command line interface
To upload the software via the command line, use the "flashnet" command described in the"General Purpose
Command Set
37
" article.
8.2.2 Checking the installation requirements
Checking the network infrastructure
If the link is not established after the installation on site, make sure that the devices were not damaged during
shipping, check the integrity of the network infrastructure, the cables and the power supplies.