Install Instructions

Infinet Wireless: Technical Documentation – InfiMAN Evolution
31 https://wiki.infinetwireless.com/display/DR/General+Purpose+Command+Set#GeneralPurposeCommandSet-system
32 https://wiki.infinetwireless.com/display/DR/General+Purpose+Command+Set#GeneralPurposeCommandSet-config
Troubleshooting – 139
•
•
•
•
•
•
•
•
•
•
•
•
•
•
8 Troubleshooting
N o acc ess to the loc al unit(see page 139)
The wirel ess link cann ot be established(see page 142)
The wi reless link is established, but there is no access to the remote device(see page 147)
The w ireless link thro ughput is lower than expected(see page 149)
Com mon errors in co nfiguration(see page 155)
Emergence Repair Console(see page 156)
Unicast-flood detection (see page 159)
8.1 N o acc ess to the loc al unit
Make sure that the connectivity is provided between the control center and the device's installation point.If the
access is missing only for the InfiNet device, further actions must be performed at the device's installation site.
Indicators(see page 139)
InfiMAN Evolution Base Station Sectors(see page 139)
InfiMAN Evolution Subscriber Terminals and InfiLINK Evolution devices(see page 140)
Access recovery(see page 141)
Checking the status of the Ethernet interface(see page 141)
Wired interface statistics(see page 141)
Duplex mode(see page 142)
8.1.1 Indicators
Pay attention to the LED indicators on the device's enclosure.
If the power and Ethernet indicators are off, check the integrity of the power supply, the Ethernet cables and the
RJ-45 connectors.Replace the power supply and the cables if necessary.
InfiMAN Evolution Base Station Sectors
LED indicators on the InfiMAN Evolution family base station sectors are located in the the cable glands ports.These
indicators help to monitor the device's status during the installation.The correspondence between the state of the
indicators and the current device state is shown in the table below.
NOTE
The LED indication on the device can be disabled administratively. Make sure there is no "system no
indicator
31
" command in the last saved device configuration. We recommend to save backup
configurations to the internal memory of the device and to a folder on your PC. The device can store 8
configuration backups. When saving the current configuration, its previous version is automatically added
to the backup list with record number 0. All operations with the device configurations are performed using
the "config
32
" command.
