Install Instructions

Infinet Wireless: Technical Documentation – InfiMAN Evolution
Operation & Administration – 136
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Parameter Description
Step Set the scanning frequency step (in MHz)
It is recommended to set 1 MHz “step” value to get more precise
scanning results
Channel Mask Select which antenna to be used for scanning the radio
environment
“Auto” parameter is set by default. In this case scanning is
perfomed by both antennas
"1" - scanning is perfomed by antenna "1"
"2" - scanning is perfomed by antenna "2"
Parameter "3" means scanning is perfomed by both antennas
Scan Duration Set the time period for the scanning process (in seconds)
After the end of this time period, scanning is stopped and the radio
interface will be back to its normal mode operation
Enable Grid Mark/unmark the corresponding checkbox to display/hide the grid
lines and highlight the special frequency channel on the scan
output
The highlighted frequency channel can be used to mark the
channel which the device is currently working on or which it plans
to use
Grid Width Set the bandwidth value for the highlighted frequency channel (in
MHz)
Grid Frequency Set the central operating frequency for the highlighted frequency
channel
RSSI mode Select the gradient-color type for the “Max RSSI” values to be
displayed on the Spectrum Analyzer output screen
The options are:
Normal (by default)
Gradient
Max Hold – holds the maximum signal values at a given
point
Peak Hold – holds the peak signal values at a given point
Scan mode "Local mode"– scanning is performed only on the local device.
"Combined mode"– Scanning is performed simultaneously on all
devices in the sector. The "Last Snapshot" button will display the
blended result
32 Table - Spectrum Analyzer
Start/stop Spectrum Analyzer by clicking the «Start Sensor Test»/«Stop Sensor Test» buttons.