Install Instructions
Table Of Contents
- About This Manual
- Important Notice
- Introduction
- Document structure
- Document marks
- Key Features
- Hardware Platform
- Power supply
- Lightning protection unit
- Synchronization unit
- // 0) { /* For each inline-commented element clear data-ref and class */ for (var i=0; i < commentedElements.length; i++) { commentedElements[i].dataset.ref= ""; commentedElements[i].className = ""; } } /* Else do nothing */ } }); //]> AUX-ODU-SYNC Mounting
- AUX-ODU-SYNC Cable gland Assembling
- AUX-ODU-SYNC Connection to ODU
- Packing List
- Planning considerations
- Link Pre-configuration in the lab
- Installation
- Operation & Administration
- Troubleshooting
- Glossary
Infinet Wireless: Technical Documentation – InfiMAN Evolution
28 ftp://ftp.infinetwireless.com%29./
Operation & Administration – 133
•
•
1.
2.
3.
80 Figure - Latest firmware change log
The process above is the same in case of Beta firmware version. Click the «Check Latest Beta» button for it.
Mass firmware upgrade
Each device has the ability to mass firmware upgrade using OTA (Over the Air) function. The firmware can be
distributed to:
All devices within a single MINT domain. The firmware will be applied even to the not directly connected
devices.
Neighbor devices, directly connected to the current.
Mass upgrade cycle includes the following steps:
Download the required firmware version from the official FTP server (ftp://ftp.infinetwireless.com).
28
Choose the downloaded firmware file in the "Upload" section. Enable OTA function. Enable "Neighbors
only" in case you want to upgrade only the neighbor devices.
Click the "Upload" button. The mass upgrade process will be started.
NOTE
Only one firmware version can be applied during one mass upgrade cycle. The uploaded firmware version
will be applied only to those devices that are built on the same platform. Thus if the upgraded network
includes devices on different platforms, the mass upgrade cycle should be performed for each platform.
In case the OTA function is enabled the uploaded firmware will not be applied to the device from which the
upgrade is performed. It will be uploaded only to the other network devices.