Install Instructions

Infinet Wireless: Technical Documentation – InfiMAN Evolution
Operation & Administration – 120
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
IP firewall rule parameter Description
Interface Set the interface for applying the new rule
All the available interfaces are displayed in the dropdown list
(physical and logical)
If “any” option is used, the rule is applied to all available
interfaces
Group Set the Switch Group number for the applying of the new rule
The Switch Group must be prior created
Rule Set the packet capture filter for IP firewall
It is the same syntax called “PCAP expression”, as in the
"Switching" section
Refer to the filter expression syntax description above
By clicking the «Validate» button, you can check the syntax in
the expression in the “Rule” field
23 Table - IP Firewall
The «Up/Down» arrows allow you to organize rules list. The rules are processed one by one in a top-down order.
7.3.7 SNMP menu
TheSNMPprotocol support is an important feature of all communication devices because it allows the system
administrator to manage the operation of a network as a whole, as well as of each component.
SNMPsection contains a set of parameters to exchange data about network activity of the device.
TheSNMPProtocol has two sides, the agent and the management stations:
The agent sends data to the management station
The management station collects data from all the agents on the network. You can set several destinations
of traps with individual set of traps as well as several users with individual access rights.
The agent sends alerts called traps (see Traps zone) and answers requests that were sent by the
management station
The management station captures and decodes the traps. The management station also requests specific
information from the agent.
The information is passed through requests and replies with the use of theMIB
The management station is responsible for decoding theSNMPpackets and providing an interface to the
administrator. The interface can be aGUIor a command line.
Access
In the "Access" section, you can view and edit the currentSNMPaccess settings; you can delete the
currentSNMPv.3 users by clicking the «Remove User» button or create new ones by clicking the «AddSNMPv.3
User» button:
SNMP access parameter Description
Start SNMP Enable/disable SNMP daemon in the device