Install Instructions

Infinet Wireless: Technical Documentation – InfiMAN Evolution
Operation & Administration – 116
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Switch Rules parameter Description
Action Set the action for the packets that match this rule: permit/deny
QM Channel Allocate a logical channel if there are logical channels prior
created in the "Traffic Shaping (see page 125)" section
If you allocate a number for a logical channel that was not prior
created in the "Traffic Shaping" section, it has no effect in the
rule configuration
For the indications how to create a logical channel, please refer
to the "Traffic Shaping" section below
Priority Allocate the priority for all the packets going through the new
rule of the filter:
“Up to” is used to increase the packet priority to the
specified value only if the processed packet has a lower
priority
“Set” is used to assign a new priority regardless of the
value already assigned to the packet
Packet capture filter Set the packet capture filter for Switching
The syntax is called “PCAP expression”
Please refer to filter expression syntax description above
Validate rule by clicking the «Validate» button
VLAN list Set the VLAN ID
It is available for the legacy configuration
It can be set also in "PCAP expression" option (for example: VLAN
100 when “PCAP expression” is chosen), PCAP expressions
cannot be used in "trunk/in-trunk mode"
Validate rule by clicking the «Validate» button
21 Table - Switch Groups Rules
IGMPSnooping
In this section you can set theIGMP-parameters for the groups for which support ofIGMPsnooping is enabled
(theIGMPcheck box is marked for these groups in the "MACSwitch" section).
NOTE
In all three types of filters: Switching, IP Firewall and Traffic Shaping, there is the same syntax called
“PCAP expression” for setting a rule. It is a universal tool for creating filters.
