Install Instructions

Infinet Wireless: Technical Documentation – InfiMAN Evolution
Operation & Administration – 115
•
•
•
•
•
•
•
•
Switch parameter Description
Default QM Channel Allocate a default logical channel
The default logical channel must be prior created in the "Traffic
Shaping (see page 125)" section
In the absence of any Switching rule, or if a packet does not match
to any Switching rule, the default logical channel is allocated
For the indications on how to create a logical channel, please refer
to the "Traffic Shaping" section below
Default Priority Allocate the default priority for all the packets going through the
Switch group:
“Up to” - used to increase the packet priority to the
specified value only if the processed packet has a lower
priority
“Set” - used to assign a new priority regardless of the value
already assigned to the packet
In the absence of any Switching rule, or if a packet does not match
to any Switching rule, the default priority is allocated
20 Table - MAC Switch
You can change the list order of the switch group using the "up/down" arrows.
A set of rules are applied to all packets within a switch group. You can create several switch rules within a switch
group. The following parameters are available for switch rules: