Instruction Manual

tina88e1-b (2014-09) 39
4.6 Activating the Factory Setting (Factory Reset)
All user defined parameters (e.g. zero, filter) are restored to their
default values.
Loading of the default parameters is irreversible.
Loading the default parameters:
 Put the gauge out of operation.
 Keep the <ZERO> button depressed for at least 5 s while
the gauge is being put into operation (Power ON).
4.7 Diagnostic Port (RS232C Interface)
The diagnostic port <DIAG> permits to output the pressure
reading and all status information and to enter all settings at the
same time (→  [3]).
When a cable is attached to the diagnostic port all other inter-
faces except the analogue outputs are automatically deactivated.
To return to normal operation after using the diagnostic port the
gauge must be power cycled.
→ "Accessories"