Owner's manual

3 - 14
IPN 074-508-P1C
CMS5000 Operating Manual
3.11 Communication Configuration
Select the desired communication configuration from the selections below.
3.11.1 Ethernet
The Ethernet port used to connect the CMS5000 to a PC or network is located on
the upper right side of the CMS5000, next to the wireless antenna. Plug the end of
the Ethernet cable with the water tight cap into the CMS5000 and plug the other
end into a PC or network. See Figure 3-18.
3.11.2 I/O
The multi-pin I/O cable receptacle is located on the right side of the CMS5000 next
to the power supply receptacle. Plug the multi-pin Fischer Connector from the I/O
cable into the CMS5000 and configure the other end of the cable as desired. See
Figure 3-18.
Figure 3-18 Connecting the Ethernet and I/O
Ethernet
I/O