User guide

10 Installation and removal
5 Installation and removal
5.1 Installation of the bus module
 DIN-TS35 top hat rail
1 Hook unit on top hat rail at bottom.
2 Press unit onto top hat rail at top.
5.1.1 Establish connections
Connection of bus module with MSB box
The bus module communicates via a data cable with the mass spectrometer module
and is supplied with voltage by means of the data cable.
 Data cables from INFICON
1 Connect bus module (connection L
D) via data cable with MSB box
(connection I/O).
Information If you disconnect the data cable from the connection L
D of the bus
module during operation, the communication between the bus module
and the MS module will be interrupted.
2 Connect the bus module with the external controller by means of the built-in
Fieldbus module.
Communication with Fieldbus master
► For information on establishing communication with the Fieldbus master, see
Interface protocols, jira54.
Fig: 2 Mount bus module on DIN-TS35 top hat rail