Installation Guide

Install Two “D” Cell Alkaline Batteries

WARNING

To prevent ignition of a hazardous atmosphere, batteries must only

be changed in an area known to be non-hazardous (i.e., free of

combustible gas).

CAUTION

Use only Duracell

MN1300 “D” size batteries to maintain

intrinsically safe approval.

1. Remove the battery cover by releasing the latch and sliding the cover down and

off the handle. You may need a small flat-blade screwdriver to assist with

releasing the latch.

2. Install two Duracell

MN1300 “D” size alkaline batteries as shown in Figure 1.

Figure 1 Properly installed alkaline batteries

3. Reinstall the battery cover by aligning it in the grooves on the handle and sliding

it up the handle until it latches.

NOTE: If the Battery indicator flashes or if the Battery and highest signal indicator

both flash, the batteries are low and should be replaced.

NOTE: Dispose of depleted alkaline batteries according to applicable state and

local regulations. In the absence of such regulations, recycle and/or

dispose of batteries through voluntary waste recycling programs.