Reference Guide

20 - 6
PN 074-558-P1A
3000 Micro GC Guides
17 On the new module, set the Performance Enhanced GC module address by setting the
DIP switch on the upper right of the D-board to the appropriate configuration. Each setting
determines a unique module address. Please refer to the label on the top of the module.
The DEF setting is the factory default DIP switch setting.
18 Remove the small metal plate covering the O-rings on the upper gang block.
Table 20-1 Changing a standard module (continued)
Step Description
Metal plate covering
O-rings and upper
gang block
Retaining screw