Operating Manual Instruction Manual

5 - 14
PN 074-519-P1C
3000 Micro GC Operating Manual
6 Insert the outlet tube into the outlet fitting on the Genie Filter Assembly. See
Figure 5-17. Tighten 1/2 turn past finger tight using the 1/4 in. open-ended
wrench, then loosen 1/4 turn so that the tube is loose but will not disengage.
Figure 5-17 Installing the sample outlet tube (PN G2816A shown)
7 Align the Pressure Reducer and Genie Filter Assembly bracket horizontally on
the 3000 Micro GC face so that the end of the outlet tubing is near the inlet
fitting. Then, place the lower lip of the mounting bracket under the bottom front
panel as shown in Figure 5-18. The edge of the 3000 Micro GC front molding
will fit into the groove in the bracket.
Figure 5-18 Installing the pressure reducer and Genie filter assembly
Insert outlet tube here
Flow adjustment knob
Remove cap
PN G2816A
G2816A