Instructions / Assembly

IB-005-2-9W-WH

IB-005-3-9W-WH

IB-005-4-9W-WH

IB-005-5-9W-WH

IB-005-6-9W-WH

4” Sleek Series Dimmable E26 Retroﬁt Downlight

3. Screw the Edison adapter into the base. 4. Connect the female connector of the kit

to the connector socket adapter .

5. Squeeze both torsion spring arms together and

insert into the torsion spring slots (or receiner

brackets) of the can. Tuck all the wires into the can

and carefully push the retrofit trim into can.

1. Make sure the power is off. Once the power is off, remove the flange and bulb.

2. Remove the mounting bracket from the socket of the inside of the light housing. Remove the socket from the bracket and remove the bracket.

Some lamp holders may not be installed on a support but fixed directly on the box. In this case ignore Step 2 and proceed to Step 3.

140

750lm

PAGE 1
4” Sleek Series Dimmable E26 Retrofit Downlight IB-005-2-9W-WH IB-005-3-9W-WH IB-005-4-9W-WH 750lm 9W 140 IB-005-5-9W-WH IB-005-6-9W-WH 1. Make sure the power is off. Once the power is off, remove the flange and bulb. 2. Remove the mounting bracket from the socket of the inside of the light housing. Remove the socket from the bracket and remove the bracket. Some lamp holders may not be installed on a support but fixed directly on the box. In this case ignore Step 2 and proceed to Step 3. 3.