User's Manual

8
LAN Status LED
If supported by the mPCIE (32) card connected, indicates LAN network
activity
9
WAN Status
If supported by the mPCIE (32) card connected, indicates WAN networ k
activity
10
DSI/CAM1
connector
Standard full-size Raspberry Pi MIPI connector that can be configured
as Display or secondary Camera (cam1) connector; selection is made
via the DSI/CAM1 switch (37)
11
HDMI
Full-size HDMI Type A with CEC support
12
CSI
connector
Standard full-size Raspberry Pi Camera (cam0) connector
13
HAT
connector
40-pin Raspberry Pi HAT (Hardware Attached on Top) standard
connector
14
WiFi/BT combo
chip
802.11ac/a/b/g/n 2.4 & 5GHz WiFi + Bluetooth 4.2
15
WiFi/BT uFL
antenna
connector
If the RF switch (33) is set on the external position, the antenna attached
to this connector will become the main radio antenna for the WiFi/BT
combo chip (14)
16
WiFi/BT
embedded
antenna
Embedded high-performance SMD antenna covering both 2.4 and 5GHz
frequencies; it is the default antenna selected for the WiFi/BT combo
chip (14)
17
Co-processor
Silicon Labs BGM111 MCU
18
USB1 ON
Status LED
The green LED stays on as long as there is enough current flowing on
the top USB port; when this LED is off, it means a fault or under-voltage
is happening on the top USB port
19
USB
2 x USB Type-A
20
USB2 ON
Status LED
The green LED stays on as long as there is enough current flowing on
the bottom USB port; when this LED is off, it means a fault or
under-voltage is happening on the bottom USB port
21
Ethernet
10/100 ethernet RJ45 connector