Technical Manual

32 - IP Reader
Name
Key Descr iption
Name
The name of this IP reader (like 'P rinter Q 745') This name w ill also be used as
host name, it is sent to the DH C P serv er and DNS serv er if they are enabled.
IP config
Key Descr iption
Dy namic Host
C onfiguration
Protocol
Enabled if DHC P be used, disabled if the netw ork information need to be filled
out manually .
IP The IP -address for the IP reader.
Netmask
The netmask (only used w hen using subnetting, ask y our sy stem
administrator, if y ou're not sure). S tandard v alue 255.255.255.0
Gatew ay
The IP address of the gatew ay (The gatew ay is de serv er that is located
betw een tw o netw orks, like the Internet and y our local netw ork). It is usually
the same address as the DN S serv er.
Domain Name
Sy stem
The IP address of the serv er w ith the Domain Name Sy stem, the sy stem tha
t
transforms names to IP -addresses and v ice v ersa.
Server config settings
Key Descr iption
Serv er 1 IP The address of the serv er that the IP reader should contact.
Serv er 2 IP
The address of the back-up serv er that the IP reader should contact. It w ill be
contacted if the first serv er does not respond.
Serv er 1 name
When DNS is used the name of the serv er can be entered, the IP-address
v alue for this serv er w ill be ignored, and retriev ed from the DNS serv er.
Serv er 2 name
When DNS is used the name of the serv er can be entered, the IP -address
v alue for this serv er w ill be ignored, and retriev ed from the DNS serv er
Key set
Key set w ill giv e the possibility to set the encry ption key betw een the IP
reader and the serv er. A t the time of w riting the v alue as not y et used and
should alw ay s be set to '1'.
Reader config settings
Key Descr iption
Setting 1
These settings w ill be addressed below .
Setting 2
Setting 3
Data 1
Data 2
These fields will be used for retrieving the card reader data. The
values entered here are dependent on the card that is used.
Note: The raw data is supplied without conversion. Below you
will find the data that applies to the data supplied in a decimal
format.