User's Manual

Technical Document

430693-00

Rev. K

Indyme Solutions, Inc. 8295 Aero Place  San Diego, CA 92123 USA +1.858.268.0717  +1.800.829.6141Page 1 of 5

CB914 Wireless Director Help Button

Programming and Installation Instructions

Introduction

The CB914 is a member of the Global Solutions Family. Indyme GSF products operate in the

800MHz ʹ 900MHz frequency spectrum. The CB914 is a 4-button, GSF, Director Help Button

designed for use at customer service or cash register locations. GSF Help Buttons

communicate with an Indyme GSF Access Point. GSF products are not compatible with

legacy devices

Programming Parameters

GSF products MUST be properly programmed to establish communication. Programming

parameters MUST match your configuration. The default settings are for testing purposes only

and should not be used. Failure to properly program your help button and access point will

prevent your devices from working.

GSF help buttons have four primary programming parameters; Frequency Plan, Netcode,

Address and Operating Mode. These MUST be programmed in the correct order to establish

communication and ensure proper operation. Identify the parameters for your configuration

before you begin programming.

Using the programming instructions below set the following parameters in order.

x Frequency Plan ʹ defines the frequency for your GSF devices.

x Netcode ʹ unique identification code for the installation environment.

x Address ʹ alarm number associated with a control unit alarm event.

x Operating Mode ʹ defines how the help button will respond when activated.

Programming a help button requires a series of button presses. The specific buttons vary by help button

type. On the CB914, SET is BUTTON-1 and RESET is a small circle below button-4. The assurance LED is

red and is located next to the SET button. This LED will flash during programming to indicate your

progress.

Frequency Plan *FP03 USA/Australia -918.100MHz

Netcode *00000001

Address *0001

Operating Mode *1

* Default parameters are for testing purposes only.

RESET

LED

CB914