User's Manual

Technical Document
<Tag Here>
Indyme Solutions, Inc. 8295 Aero Place  San Diego, CA 92123 USA +1.858.268.0717  +1.800.829.6141 Page3 of 6
Menu-2: Learn Mode
Allows the help button to capture the Netcode from another GSF device; (help button or access point).
All help buttons and access points must have the same Netcode to communicate.
After entering the Programming Menu;
Press the SET button two times for Menu-2, RESET once to save.
The LED will flash twice to indicate Menu-2 was selected.
The LED will then begin flashing. ¼ second on, 1 second off. This indicates that the help button is
requesting a Netcode. When the help button receives a Netcode, it will flash the assurance LED
rapidly for approximately 3 seconds and then it will exit Menu-2. If no Netcode is received
within 5 minutes, the help button will exit Menu-2.
Menu-3: Operating Mode
Assigns the help button operating characteristics; timeout duration, RESET signal and number of active
buttons. Although set at the help button, the Operating Mode can be reset and overridden by the
control unit. Operating Modes will vary by help button type, below are the default modes for this help
button.
After entering the Programming Menu;
Press the SET button three times for Menu-3, RESET once to save.
The assurance LED will flash three times to indicate Menu-3 was selected.
Press the SET button to select a Help button KƉĞƌĂƚŝŶŐDŽĚĞфϭϮхRESET once to save.
The assurance LED will flash to indicate the selected Operating Mode.
x Mode 1 - Standard 5-min timeout, No Reset
Press the SET button to trigger the alarm state; the LED will flash for 5 minutes, then extinguish
with no reset sent. The RESET button will send a reset signal for the active channel.
x Mode 2 - Standard 30-sec timeout, No Reset
Same as above, with 30-second timeout.
Menu-7: Clone Mode
Allows the help button to broadcast the Netcode to other GSF help buttons. All help buttons and access
points must have the same Netcode to communicate.
After entering the Programming Menu;
Press the SET button seven times for Menu-7, RESET once to save.
The assurance LED will flash seven times to indicate Menu-7 was selected.
The assurance LED will now flash a cadence of 4-pause, 4-ƉĂƵƐĞĞƚĐdŚĞhelp button will stay
in Clone mode for 5-minutes or until the RESET button, is pressed.
Menu-8: Frequency Plan Mode
Assigns the designated frequency spectrum to the help button. All help buttons and access points must
have the same Frequency Plan to communicate.
After entering the Programming Menu;
Press the SET button eight times for Menu-8, RESET once to save.
The assurance LED will flash eight times to indicate Menu-8 was selected.
Press the SET button to select a Frequency Plan: <1, 2, 3 or 4>, RESET once to save.
The assurance LED will flash to indicate the selected Frequency Plan.
The four Frequency Plans are as follows;
x FP01Europe -868.175MHz
x FP02 USA/Australia -918.000MHz
x FP03 USA/Australia -918.100MHz
x FP04 USA/Australia/Singapore -920.000MHz