User's Manual
Technical Document
430694-00
Rev. J
Indyme Solutions, Inc. 8295 Aero Place San Diego, CA 92123 USA +1.858.268.0717 +1.800.829.6141Page 1 of 6
CB940 Wireless Help Button
Programming and Installation Instructions
Introduction
The CB940 is a member of the Global Solutions Family. Indyme GSF products
operate in the 800MHz ʹ 900MHz frequency spectrum. The CB940 is a 1-button,
GSF, Director Help Button designed for use at customer service or cash register
locations. GSF Help Buttons communicate with an Indyme GSF Access Point.
GSF products are not compatible with legacy devices
Hardware
x (1) pad, double sided adhesive
x (2) strips, double sided adhesive
x (1) strip, Velcro
Programming Parameters
GSF products MUST be properly programmed to establish communication.
Programming parameters MUST match your configuration. The default settings are
for testing purposes only and should not be used. Failure to properly program your
help button and access point will prevent your devices from working.
GSF help buttons have four primary programming parameters; Frequency Plan, Netcode, Address and
Operating Mode. These MUST be programmed in the correct order to establish communication and ensure
proper operation. Identify the parameters for your configuration before you begin programming.
Using the programming instructions below set the following parameters in order.
x Frequency Plan ʹ defines the frequency for your GSF devices.
x Netcode ʹ unique identification code for the installation environment.
x Address ʹ alarm number associated with a control unit alarm event.
x Operating Mode ʹ defines how the help button will respond when activated.
Programming a help button requires a series of button presses. The specific buttons vary by help button
ƚLJƉĞKŶƚŚĞϵϰϬ^dŝƐƚŚĞWZ^^,ZďƵƚƚŽŶĂŶĚZ^dŝƐĂƐŵĂůůĐŝƌĐůĞĂďŽǀĞƚŚĞ/ŶĚLJŵĞŶĂŵĞĂƚ
the bottom of the help button. The assurance LED is red and is located next to the SET button. This LED will
flash during programming to indicate your progress.
Frequency Plan *FP03 USA/Australia -918.100MHz
Netcode *00000001
Address *0001
Operating Mode *1
* Default parameters are for testing purposes only.
LED
CB940
RESET