User's Manual

Indyme Solutions, Inc. 8295 Aero Place  San Diego, CA 92123 USA +1.858.268.0717  +1.800.829.6141Page 4 of 7
Technical Document
430696-00
Rev. J
Menu-8: Frequency Plan Mode
Assigns the designated frequency spectrum to the help button. All help buttons and access points must
have the same Frequency Plan to communicate.
After entering the Programming Menu;
Press the SET button eight times for Menu-8, RESET once to save.
The assurance LED will flash eight times to indicate Menu-8 was selected.
Press the SET button to select a Frequency Plan: <1, 2, 3 or 4>, RESET once to save.
The assurance LED will flash to indicate the selected Frequency Plan.
The four Frequency Plans are as follows;
 (1) FP01 Europe -868.175MHz
 (2) FP02 USA/Australia -918.000MHz
 (3) FP03 USA/Australia -918.100MHz
 (4) FP04 USA/Australia/Singapore -920.000MHz
Installation
1. Identify all programming characteristics before you begin programming or installation.
 Frequency Plan
 Netcode
 Help button Addresses
 Help button Modes
2. Program the required parameters into the CB951 Access Points first.
3. Set the corresponding Frequency Plan on each of the help buttons.
4. Use the first CB951 Access Point to clone the Netcode to all of the help buttons. This will ensure the
same Netcode is being assigned to all devices. You may also clone the Netcode from a known
working help button to all other help buttons. The Netcode cannot be cloned from a help button to
an access point.
5. Program the Alarm Address and Mode of each help button.
6. Install the help button in accordance with store policy, Indyme work order and/or Americans with
Disabilities Act guidelines where applicable.
The CB975 Help button uses one 2/3A 3-volt lithium battery. Always use the same type of battery for
optimum performance. DO NOT use rechargeable batteries in the help button.
To replace the batteries,
remove the 2-phillips screws from the back cover. Remove the old battery from the battery holder.
Install the new 2/3A 3-volt lithium battery and replace the cover. (**) The help button does not lose the
programmed characteristics when the batteries are removed.