User's Manual
Indyme Solutions, Inc. 8295 Aero Place San Diego, CA 92123 USA +1.858.268.0717 +1.800.829.6141Page 1 of 7
Technical Document
430696-00
Rev. J
CB975 Wireless Help Button
Programming and Installation Instructions
Introduction
The CB975 is a member of the Global Solutions Family. Indyme GSF products operate in the
800MHz ʹ 900MHz frequency spectrum. The CB975 is a 1-button, GSF Help button
designed for use at Customer Service locations. GSF Help buttones are designed to
communicate with a GSF Access Point. GSF products are not compatible with legacy
devices
Programming Parameters
GSF products MUST be properly programmed to establish communication. Programming
parameters MUST match your configuration. The default settings are for testing purposes only
and should not be used. Failure to properly program your help button and access point will
prevent your devices from working.
GSF Help buttons have four primary programming parameters; Frequency Plan, Netcode, Address and
Operating Mode. These MUST be programmed in the correct order to establish communication and
ensure proper operation. Identify the parameters for your configuration before you begin programming.
Using the programming instructions below set the following parameters in order.
Frequency Plan ʹ defines the frequency for your GSF devices.
Netcode ʹ unique identification code for the installation environment.
Address ʹ alarm number associated with a control unit alarm event.
Operating Mode ʹ defines how the help button will respond when activated.
Programming a help button requires a series of button presses. The specific buttons vary by device type.
On the CB975, SET is ƚŚĞWZ^^,ZďƵƚƚŽŶand RESET is a small circle to the right of the Indyme
name at the bottom of the help button. The assurance LED is red and is located next to the SET button.
This LED will flash during programming to indicate your progress.
Frequency Plan *FP03 USA/Australia -918.100MHz
Netcode *00000001
Address *0001
Operating Mode *1
* Default parameters are for testing purposes only.
CB975
LED
RESET