Installation Instructions
Indyme Solutions, Inc.⬧ 8295 Aero Place ⬧ San Diego, CA 92123 USA +1.858.268.0717 ⬧ +1.800.829.6141 Page 5 of 6
Technical Document
430773-02
Rev. 5
Mounting
1. Remove the CB967 from its packaging and disassemble before mounting.
2. Identify the desired mounting height for the help button, typically 48” – 54” above the floor.
3. Secure the base mounting plate with appropriate hardware:
a. Lanyard, with screw under counter – Using included rubber feet
b. Velcro/Adhesive – Clean surface with included alcohol swap
c. Screws and anchors – Remove rubber feet and use existing holes in base plate
4. Insert included batteries paying attention to polarity
5. Align the help button module over the base plate and slide it back until it is clicked into position.
6. From the final mounting location, press the SET button on the help button and verify the
appropriate assurance message is heard locally and that the correct message is broadcast over the
desired output device.
Battery holders
Batteries Installed
Base Mounting Plate