Installation Instructions

ManualsBrandsIndyme Solutions ManualsElectronicsNext Gen Help Button

Indyme Solutions, Inc.⬧ 8295 Aero Place ⬧ San Diego, CA 92123 USA +1.858.268.0717 ⬧ +1.800.829.6141 Page 2 of 6

Technical Document

430773-02

Rev. 5

Enter the Programming Menu

Press and hold the RESET button until the assurance LED flashes one time.

Press and hold the SET button, until the assurance LED flashes two times.

Press and hold the RESET button, until the assurance LED flashes three

times.

The help button is now in the Programming Menu mode, proceed to the

desired submenu.

Menu-1: Address Programming

Assigns the help button to a corresponding alarm event programmed in the control unit. A help button

address is a four digit number from 0001 to 4095. Leading zeros are required.

After entering the Programming Menu;

Press the SET button one time for Menu-1, RESET once to select.

The assurance LED will flash one time to indicate Menu-1 was selected.

Use SET and RESET to program the 4-digit address as follows;

SET = digits 1-9, RESET = digit 0 and SAVE. Leading zeros are required

For example, programAlarm-0802 as follows:

▪ Press RESET once to represent the zero. (0)

▪ Press SET eight times, RESET once to save. (8)

▪ Press RESET once to represent the zero. (0)

▪ Press SET two times, RESET once to save. (2)

Note: When the RESET button is pressed to save the 4

digit, the assurance LED will flash to indicate the

address that was entered. The assurance LED will indicate digit zero by a long flash. (approximately 1-

sec.)

Menu-2: Learn Mode

Allows the help button to capture the Netcode from another GSF device; (help button or access point).

All help buttons and access points must have the same Netcode to communicate.

After entering the Programming Menu;

Press the SET button two times for Menu-2, RESET once to select.

The LED will flash twice to indicate Menu-2 was selected.

The LED will then begin flashing. ¼ second on, 1 second off. This indicates that the help button is

requesting a Netcode. When the help button receives a Netcode, it will flash the assurance LED

rapidly for approximately 3 seconds and then it will exit Menu-2. If no Netcode is received

within 5 minutes, the help button will exit Menu-2.

Reset

Set

Programming

Address

Clone

Learn

Operation

Menu 1

Menu 7

Menu 3

Menu 2