Installation Instructions

Indyme Solutions, Inc.⬧ 8295 Aero Place ⬧ San Diego, CA 92123 USA +1.858.268.0717 ⬧ +1.800.829.6141 Page 5 of 6
Technical Document
430773-01
Rev. 5
Mounting
1. Remove the CB966 from its packaging and disassemble before mounting.
2. Identify the desired mounting height for the help button, typically 48” – 54” above the floor.
3. Install the desired mounting hardware to the sign blade, following the included instructions for that
mounting kit.
4. Insert included batteries paying attention to polarity
5. Align the cover over the electronics module and secure into position with the two (2) screws.
6. From the final mounting location, press the SET button on the help button and verify the
appropriate assurance message is heard locally and that the correct message is broadcast over the
desired output device.
Battery holders
Batteries Installed
Secure side cover