Installation Instructions

Technical Document

CB440/511 Install Instructions 1 P/N: 430223-00 Rev H

CB440/CB511 Installation And Programming Instruction

Individual callbox addresses should be determined prior to starting the installations. As an un-

programmed callbox defaults to an address of 001, this position in the control unit may be left blank

or have an advisory message.

Location Considerations

Call boxes are generally best located at areas that require

assistance to access store merchandise, such as high

shelving, chain and rope cutting, key machine, etc. Stores

and installers should be aware of Americans With Disabilities

Act (ADA) requirements for accessibility.

The call boxes utilize a very low powered transmitter, and

operate best with a clear line of sight to the nearest receiver.

Tall shelving, merchandise and metal signs can block or

reduce the callbox signal.

Install the Call Box

1. Verify call box placement with the Store Manager and determine the best mounting

method. Note: Before installing the call box, verify address programming.

• If mounting the call box to glass display case, affix the double-sided foam tape to the

back panel of the call box.

• If mounting the call box to the wall, affix the Velcro tape to the back panel of the call

box.

• If mounting the call box to a wood surface, open the call box and use the included

hardware to secure the call box to the wooden surface. (CB440 only)

2. Install the back panel with the provided hardware.

Programming CB440/CB511 Call Box Address

NOTE: IF INSTALLED, JUMPER JP2 MUST BE REMOVED DURING PROGRAMMING.

WHEN POWERED UP, THE CALL BOX WILL DEFAULT TO 001.

The Address and Mode for each call box are listed in the Store Installation and

Operation Manual for the specific store install. Refer to the data tables in Appendix A of

the Store Installation and Operation Manual for the correct Mode and Address for each

call box you are programming.

1. Press and hold the RESET button for approximately 5 seconds.

2. LED 1 will flash to indicate the call box is in address programming mode.

3. Press button 1 to increment the hundreds digit. LED 1 will flash with each press.

4. Press the RESET button when finished with the hundreds digit.

5. Press button 1 to increment the tens digit. LED 1 will flash with each press.

CB440 (above)

and CB511 (right)

PAGE 1
Technical Document CB440/CB511 Installation And Programming Instruction Individual callbox addresses should be determined prior to starting the installations. As an unprogrammed callbox defaults to an address of 001, this position in the control unit may be left blank or have an advisory message. Location Considerations Call boxes are generally best located at areas that require assistance to access store merchandise, such as high shelving, chain and rope cutting, key machine, etc.
PAGE 2
Technical Document 6. 7. 8. 9. Press the RESET button when finished with the tens digit. Press button 1 to increment the ones digit. LED 1 will flash with each press. Press the RESET button when finished with the ones digit. The address just programmed should flash back on the LED 1 with a pause between each digit. (Note: the LED will indicate a zero value by staying on for a longer period of time, approximately 1 second). JP4 Pulse Width: must be installed for Narrow Pulse Width operation and programming.