User's Manual

2. Capacity

The CU5300/5303W

• Supports a minimum of 4,000 wireless device capability (i.e., 0001 – 3999)

• Supports a minimum of 1,000 Ethernet inputs that are separated from the wireless addresses

• Supports a minimum of 60 minutes of audio storage

3. RF Output

The CU5300/5303W

• Frequency Range: 868.175 - 869.675 MHz and 918.1 – 923.0 MHz

• Modulation Type: 2-GMSK frequency hopping spread spectrum

• Antenna Type: Omni-Directional dipole, +2dBi maximum gain, RP-SMA connector

4. Ethernet

The CU5300/5303W

• Supports a standard 802.3 10/100 Ethernet connection.

• Supports 802.3af and 802.3at

• Uses a standard RJ45 connector with indicator LEDs for troubleshooting.

• Appliance is able to accommodate fixed and DHCP IP addressing.

5. Universal Serial Bus (USB)

• Two (2) USB connections are available on the controller.

• The USB ports are secured to minimize risk exposure.

• The USB ports will be used for various system and variable updates only.

6. Audio Ports

Direct Audio 1

• Direct Audio 1 is typically used to connect to a Public Address (P.A.) system.

• Direct Audio 1 has Audio In, Audio Out, Busy In, and a seize out (same as the Direct Audio 1 port on

the CLX/CLT).

• Direct Audio 1 is a standard RJ45 with the same pinouts as current CU’s

• Direct Audio 1 has an Input and an Output allowing another audio source to be looped through the

appliance.

• The appliance is able to switch between the external audio source (Audio In) and the internal audio

output as needed.

• The powered down and default mode allows the audio to pass from Audio In to Audio Out.

• The appliance is able to monitor Audio In for busy status (VOX). This feature is selectable on/off.

Direct Audio 2

• Direct Audio 2 is typically used to connect to an Indyme PT transceiver.