User's Manual

• Direct Audio 2 has an Audio In, Audio Out, Busy In, and a PTT out (same as the Direct Audio 2 port on

the CLX/CLT).

• Direct Audio 2 is a standard RJ45 with the same pinouts as current CU’s.

• This port is used with existing PT14 and PT14-1 units, and will be 100% reverse compatible.

7. Controls and Indicators

• Direct Audio 1 has a bi-colored status LED

• Green = Ready

• Red = Busy (Vox mode only)

• Amber = In use (audio outputting)

• Direct Audio 2 has a bi-colored status LED

• Green = Ready

• Red = Busy (carrier presence contact or audio input presence, depending on mode, e.g., PT14-4 vs.

PT14-1)

• Amber = In use (PTT seize)

• Power/Heartbeat/Error has a bi-colored status LED

• Flashing Green = Good

• Flashing Red = Error

• Volume control consists of two (2) push buttons (same/similar to CLX/CLT)

• Used to select Audio 1 or Audio 2

• Used to increase or decrease volume levels

• Volume level indicated on Direct Audio 1 or Direct Audio 2 LED while adjusting

• Can use same method used on CLX/CLT, where cadence of flashing LED indicates volume level.

• Slow flash = low volume

• Rapid flash = high volume

• There is also a means to adjust the volume for Audio 1 and Audio 2 independently via the GUI. This

allows the user to adjust using a numbers scale as opposed to the flash rate on the LED.

8. Shopper and Director Call Box Support

• All current (as of EFS release date) Shopper & Director call boxes are supported in the CU5300/5303W.

• The default configuration will support up to ten (10) call boxes.

• A License key or other method of unlocking features is not currently supported, but will be

implemented in a future sw release for additional shopper call box support.

9. SmartSense Device Support

• All current (as of TDD release date) GSF SmartSense devices are supported in the CU5300/5303W.

• The default configuration supports up to ten (10) devices.