User's Manual

ManualsBrandsIndyme Solutions ManualsElectronicsWireless Help Button

Technical Document

Indyme Solutions, Inc. 8295 Aero Place  San Diego, CA 92123 USA +1.858.268.0717  +1.800.829.6141 Page 2 of 5

GSF Help Button Programming

GSF help buttons function in the 800MHz – 900MHz frequency spectrum. These wireless transceivers

communicate with the Indyme CB951 Access Point. Each help button MUST be programmed with the correct

parameters to match the CB951 Access Point(s). Help buttons use a hierarchy based menu structure. You must

enter the Programming Menu first, to select the desired submenu. Each submenu may have one or more

options available. These options are used to assign specific operational characteristics to the help button.

Review the submenus/options before you begin programming. The submenus/options will vary by help button

model.

Enter the Programming Menu

Press and hold the RESET button until the assurance LED flashes one time.

Press and hold the SET button, until the assurance LED flashes two times.

Press and hold the RESET button, until the assurance LED flashes three times.

The help button is now in the Programming Menu mode, proceed to the desired submenu. (***)

Menu-1: Address Programming

Assigns the help button to a corresponding alarm event programmed in the control unit. A help button address

is a four digit number from 0001 to 4095. Leading zeros are required.

After entering the Programming Menu;

Press the SET button one time for Menu-1, RESET once to save.

The assurance LED will flash one time to indicate Menu-1 was selected.

Use SET and RESET to program the 4-digit address as follows;

SET = digits 1-9, RESET = digit 0 and SAVE. Leading zeros are required

For example, program Alarm-0802 as follows:

 Press RESET once to represent the zero. (0)

 Press SET eight times, RESET once to save. (8)

 Press RESET once to represent the zero. (0)

 Press SET two times, RESET once to save. (2)

Note: When the RESET button is pressed to save the 4

digit, the assurance LED will flash to indicate the

address that was entered. The assurance LED will indicate digit zero by a long flash. (approximately 1-sec.)

Menu-2: Learn Mode

Allows the help button to capture the Netcode from another GSF device; (help button or access point). All help

buttons and access points must have the same Netcode to communicate.

After entering the Programming Menu;

Press the SET button two times for Menu-2, RESET once to save.

The LED will flash twice to indicate Menu-2 was selected.

The LED will then begin flashing. ¼ second on, 1 second off. This indicates that the help button is

requesting a Netcode. When the help button receives a Netcode, it will flash the assurance LED rapidly

for approximately 3 seconds and then it will exit Menu-2. If no Netcode is received within 5 minutes,

the help button will exit Menu-2.

Programming

Address

Learn

Operation

Clone

Menu-1

Menu-2

Menu-3

Menu-7