User Manual

Technical Document
CB550 Installation/Programming Instructions Page 4 P/N 430563-05 Rev B
Programming the Mode: Using Buttons 7 and 9
Press and hold Membrane Switch buttons 7 and 9 simultaneously for about seven seconds to
place the unit in Mode Programming Mode. Status LED 2 will flash and you will hear a short
beep when the buttons have been held down long enough.
1. Press button 1 to increment the Mode value. Status LED 1 will flash and you
will hear a short beep with each press.
2. Press button 12 to SAVE the new Mode value. The mode value will flash
back on Status LED 1.
3. Status LED 3 will flash once to indicate that House Code "1" is programmed.
Example: Programming Mode 2
1. Press and hold buttons 7 and 9 until Status LED 2 flashes and/or you
hear a short beep. (Approximately seven seconds)
2. Press button 1 twice.
3. Press button 12 to SAVE.
4.
Verify that Status LED 1 flashes twice.
3
6
9
12
2
5
8
11 10
7
4
12 11 10
1
4
7
2
5
3
6
8 9
1
Figure 3: Number Sequence of Membrane Switches
Note: Though the Membrane Panel has 24 buttons, it is divided into two sets of 12 buttons,
numbered 1 through 12. You can use any number from either set, but you can use each number
only once. When using Button 1 from one set, Button 1 from the other set cannot be programmed
for a separate function. The buttons are in parallel with one another and Button 1 from either set
will be operate the same as Button 1 of the other set.
FCC Notice Of Compliance: This equipment complies with Part 15 of the FCC Rules. Any
changes or modifications not expressly approved by the manufacturer could void the user's
authority to operate the equipment.