User's Manual

Indyme Electronics, Inc.
CB520 Programming Instructions
3
P/N 430489-00 Rev D
• Mode 4 - CU3000 Backwards Compatible
Mode 4 is basically Mode 1 without Supervisory TX. This mode is backwards
compatible with CU3000 systems. **Note: to work with a CU3000, the DAT
file will need to be modified. Button mapping is slightly different than the
CB500A.**
• Mode 5 – Variable Response with Acknowledge
An external switch contact transition will trigger a button 12 "alarm state"
(contact shared with button 12), the Active LED flashes and continues to flash
for 300 seconds. For example: when Button 1 is designated as the
Acknowledge Button, pressing Button 1 also acknowledges Button 12, the
Active LED flashes at a faster rate and continues to flash for 300 seconds.
Buttons 2-11 are designated as Reason Buttons and send a set transmission
for the button pressed. This mode must be used with the CB520-ACK script
to associate the correct reason code with the original alarm.
Installation
The CB520 call box arrives with two Velcro strips affixed to the back of the call
box. To mount the call box, thoroughly clean the mounting surface with alcohol,
removing all dirt from the mounting surface. Remove the tape from the Velcro
strips and press the call box firmly into position – typically located near a register
or telephone at a checkout counter or service desk.
FCC Notice Of Compliance: This equipment complies with Part 15 of the FCC Rules. Any changes
or modifications not expressly approved by the manufacturer could void the user's authority to
operate the equipment.