User's Manual

CB432 Programming & Install Instructions
2 P/N 430673-01 Rev B
Menu-1: Call Box Address Programming
Assigns the call box to a corresponding alarm event programmed in the control unit. A call box
address is a three digit number from 001 to 999. Leading zeros are required.
After entering the Programming Menu;
Press the SET button one time for Menu-1, RESET once to save.
The assurance LED will flash one time to indicate Menu-1 was selected.
Use SET and RESET to program the 3-digit address as follows;
SET = digits 1-9, RESET = digit 0 and SAVE. Leading zeros are required
For example, program Alarm-082 as follows:
 Press RESET once to represent the zero. (0)
 Press SET eight times, RESET once to save. (8)
 Press SET two times, RESET once to save. (2)
Note: When the RESET button is pressed to save the 3
rd
digit, the assurance LED will flash to
indicate the address that was entered. The assurance LED will indicate digit zero by a long
flash. (approximately 1-sec.)
Menu-3: Call Box Operating Mode
Assigns the call box operating characteristics; timeout duration, RESET signal and number of
active buttons. Operating Modes will vary by call box type, below are the default modes for this
call box.
After entering the Programming Menu;
Press the SET button three times for Menu-3, RESET once to save.
The assurance LED will flash three times to indicate Menu-3 was selected.
Press the SET button to select a Call Box Operating Mode: <1, 2, >, RESET once to
save.
The assurance LED will flash to indicate the selected Operating Mode.
 Mode 1 - 1-Button Call Box 5-min timeout, No Reset
Press the SET button to trigger the alarm state; the LED will flash for 5 minutes, then
extinguish with no reset sent. The RESET button will send a reset signal for the
active channel.
 Mode 2 - 1-Button Call Box 30-sec timeout, No Reset
Same as above, with 30-second timeout.