Installation Instructions

Indyme Solutions, Inc. 8295 Aero Place  San Diego, CA 92123 USA +1.858.268.0717  +1.800.829.6141 Page 2 of 4

Technical Document

430776

Rev.

Indyme’s help buttons and sensors use a low powered transmitter, and operate best with a clear line of

sight to the nearest access point. Tall shelving, merchandise and metal signs can block or reduce the help

button signals.

Mounting

1. Remove the AP9100 from its packaging.

2. Identify the desired mounting location and determine the best mounting option:

Wall Mount:

3. For wall mounting use the keyholes on the backside of the AP9100 and space your screws 2.25” apart.

a. After mounting make sure antenna is unfolded and pointing straight up away from the AP9100

housing.

Ceiling Beam Mount:

4. For ceiling beam mounting use the included bracket to secure the AP9100 to the beam.

a. Wood Beam – secure the included bracket to the AP9100 and then secure the bracket to the wood

beam with appropriate screws.

b. Metal Beam – secure the included bracket to the AP9100 and then secure the bracket to the metal

beam with the included tie wraps.

c. After mounting, spin the antenna so that it is pointing down towards the floor.

Drop Ceiling Tiles:

5. For drop ceilings with tiles use the optional CB71 T-Rail Ceiling bracket (not included). Secure the CB71

bracket to the AP9100 and then secure the CB71 to the drop ceiling T-Rail.

a. After mounting, spin the antenna so that it is pointing down towards the floor.

Wiring Considerations

• The AP9100 is a PoE device and requires connection to the stores LAN/WAN in order to operate.

o Customer designated LAN/WAN PoE port

o Indyme provided PoE switch

o Single PoE injector with the LAN port connected to Net port on the control unit

• PoE wire runs cannot be over 300 feet.

• Locate the identified MDF or IDF that is closest to the desired installation location.

• Leave at least 15 feet of excess cable at the Access Point location in the event that the unit

needs to be relocated.

• Provide proper strain relief for the cable at the Access Point.