Instruction Manual

Step : Insert junction box assembly thru ceiling cut-out.

Step : 4″ Unit: Attach junction box to threaded stud using wing

nut, securing assembly to housing ring.

6″ and 8″ Unit: Attach junction box to bracket using two (2) screws,

securing assembly to housing ring (as shown).

Step : Push LED housing thru housing ring.

Step : Align slotted holes (3) of housing with screw holes on hous-

ing ring and secure with 3 screws (supplied). Align edge of housing

flush with ceiling before tighten screws. Make sure screws are fully

engaged.

Step : Install trim, completing installation.











INSTALLATION INSTRUCTIONS

For VC/VW & BBD, LRM4, LRM6, LRM8

Install from Below

3 of 3

Technical Services Phone (888) 387-2212

1300 S. Wolf Road • Des Plaines, IL 60018 • Phone 800-323-5068 • Visit us at www.acuitybrands.com/Indy

DISCONTINUED