Data Sheet

Page

Cat. Nº: ABOX-104-001-71

5 How to connect PLC Arduino to PC

- Connect USB port from PLC to PC.

NOTE:

Ardbox Family use micro USB cable.

- Open Arduino IDE interface:

- Select Industrial Shields boards -> Ardbox Family

- Select the correct Ardbox Relay Board.

If it is used the latest version of Industrial Shields boards it will appear 4 different Ardbox Relay

boards:

The ones that have to be used for the 104-001-71 Ardbox Relay HF are the following ones:

 Ardbox Relay HF w/ HW RS-485

 Ardbox Relay HF w/ HW RS-232

* HW is the abbreviation of Hardware, so depending on the Hardware Serial it will be used, it is

needed to select one or the other. See section 11 to configure the equipment to work with RS-

232 Hardware Serial or RS-485 Hardware Serial.

If it is not used the RS-232 & RS-485 it is needed to select the board Ardbox Relay HF w/ HW

RS-485. See section 9-10 to enable the features that are disabled if using RS-485 protocol that

will get enabled as there is no RS protocol.