Manual

DT 200 Users Manual version 1.E Set Operation Parameters
26
2 - CONDEC: <st><polarity><weight><units><mode>>status><terminate>
Polarity: space (positive weight), - (negative weight)
Weight: 7 characters, zero blanked, with decimal point
Units: L (lb), K (kg), T (ton), G (gram), O (oz)
Mode: G (gross mode), N (net mode)
Status:
<space> (valid weight), M (motion), O (over wt), I(invalid)
Terminate: lf, cr (line feed, carriage return)
3 - WEIGHTRONIX: <mode1><mode2><polarity><weight><space><units><term>
Mode1: space (gross mode), 0 (zero if net mode)
Mode2: G (gross mode), N (net mode)
Polarity: + (positive weight), - (negative weight)
Weight: 6 characters, NOT zero blanked, with decimal point
Units: lb, kg, oz, g <space>(gram), t<space> (ton), tn (tonne)
Terminate: lf, cr (line feed, carriage return)
4 - OHAS: <polarity><weight><space><units><2 spaces><mode><status><term>
Polarity: space (positive weight), - (negative weight)
Weight: 7 digits, zero blanked, with decimal point
Units: lb, kg, oz, g <space>(gram), t<space> (ton), tn (tonne)
Mode: G (gross mode), N (net mode)
Status: <space> (valid weight), M (motion), O (over wt), I(invalid)
Terminate: lf, cr (line feed, carriage return)
5 - Print label 85: transmits the contents of parameter 85 (print label 85)
Data entered into a print label can include register data:
[253] [reg no] buffer register data, minimum size (zero blanked no spaces)
[254] [reg no] buffer data, 7 character field, zero blanked, right justified.
Printer Parameters
The DT200 provides a universal printer interface for various printers. The printer
interface allows you to select and customize the data output for serial or parallel printers.
The serial interface option uses Serial Port 1 (TB1) for connection to the printer. The
parallel interface uses the TTL I/O Port (TB4) for connection to the printer. Refer to the
“HARDWARE INSTALLATION AND WIRING “ section for information on connector
pin designations. NOTE: The parallel interface may not be available if the DT200 is
configured to use setpoint outputs.
Parameter 29 Printer Port Select (2 [Serial Port 1])
Enter a number from the following list to select a printer option:
1 Parallel Printer interface.