Manual

DT 200 Users Manual version 1.E Set Operation Parameters
22
Parameter Functions
Fn. No Function Name Password Level
59 Display Calibration Audit Number 0
60 3
61 3
62 3
63 3
64 Configure Passwords 2
65 Configure Print Formats 2
66 Set Time and Date 2
67 Display Operation Parameters 0
68 Print Operation Parameters 0
69 Diagnostic Tests 0
70 Initialize Operation Parameters to factory defaults. 3
71 Configure Event Monitor 2
72 Function Editor 2&3
73 Initialize Function Memory 2
74 Set Debug mode for Event monitors and Scale basic fns. 2
75 Enable Peak Detect (optional) 2
76 Set debug mode for event monitors and scale basic fns. 2
78 Erase Id Memory 1
79 3
80 3
81 Analog output offset (default = 0) 1
82 Analog output span (default = 10,000) 1
83 Analog output register (default = 0 [disabled]) 1
84-90 Print labels 4 to 10
91 Serial Port 3 mode 4
92 Serial Port 3 baud rate 1
93 Serial Port 3 input format (default = 1 [Condec]) 1
Scale Parameters
The scale parameters configure DT200 for the weigh platform or load cell that it is
connected to. The preceding table titled “SCALE PARAMETERS” lists the scale
parameters and their factory settings. Use the “Field Setting” column to record any
changes made to the factory default values.
The numbers in parenthesis are the default factory settings.