User Manual

2. Ports and receiver mode sets like the bellowing diagram: First Enable Seria_RX for uart2 and Set
Receiver mode RX_SERIAL , Select SBUS signal in Cleanflight configurator.
3. Binding Procedure:
a)Power for the BEECORE while Jumped the two “Bind” Pins, the LED Combo (2 Red and 2 White)
will getting to be solid, this means the BEECORE is in binding mode.
b)Turn on your Radio and select D8 mode for the Receiver. Then Go to the Receiver [Bind] option,
and ENT to Binding with the BEECORE. The LED Combo (2 Red and 2 White) will turning off and then
get to be solid if binding successfully. Reconnect the battery to the BEECORE after Binding successfully.
c)You should Disconnect the two “Bind” Pins after binding successfully. Please repeat the above
operation if binding not success.