User Manual

3. Installation and Connection diagram：
Pleas
e pay attention to the motor sequence of Inductrix main board , it’s different from
BEECORE, Install the motor according to the diagram above.
4. Cleanflight
/ Betaflight configuration：
All the configuration was set up before shipping, if you need to flash firmware and select Full chip erase,
you should reconfigure for the BEECORE Flight controller board according to the bellowing diagram.
Pleas
e unplug the motor from the BEECORE when you need to flash firmware and “Full chip
erase”, otherwise it will can’t connect to the Clenflight configurator.
Reconfigure steps:
1. Cleanflight: Go to the CLI tab, type “Set motor_pwm_rate=1000” ,then enter save
Betaflight: Go to Configure Tab and set ESC/Motor protocol to BRUSHED
*This step is in order to avoid motor auto-spinning when connect the battery