User's Manual
9
Remember…operator error is not covered by warranty!
10
STORAGE AND TRANSPORTATION
- Your B2K must be clear of all paint and propellant when not being used.
- Be sure the on-off switch is off and the LED is not lighted.
- Put the barrel plug in place.
- Make sure the gun is clean.
- Store your B2K in a clean, cool, dry place.
- Keep your B2K away from children.
This air gun is not a toy! To be used by adults only!
Your B2K must be clear of all paint and any source of propellant during
transportation to and from the playing field. Keep your barrel plug in place. Keep
the on-off switch in the off position. Protect your B2K from excessive heat during
transportation. Observe and obey all local, state and federal laws concerning the
transportation of paintball guns. For information concerning any of the laws in
your area, contact your nearby friendly law enforcement agency.
IMPORTANT: Never carry your B2K uncased when not on a playing field. The
non-playing public and law enforcement personnel may not be able to distinguish
between a paint marking device and firearm. For your own safety and to protect the
image of the sport, always carry your B2K in a suitable gun case or in the box in
which it was shipped.
If you must ship your B2K for any reason, the box in which you purchased the gun
is acceptable to all major carriers. Never ship charged CO2 or pressurized gas
containers.
ADJUSTING THE TRIGGER PULL
You will notice three(3) screws in your trigger. These screws adjust the length
of pull,actuation point and spring tension of the trigger. The bottom screw
adjusts your trigger stop point (length of pull). The top screw is the contact
point for your micro switch or actuation point. The center screw is the spring
tension adjustment screw.
1. Use blue loctite while adjusting the screws. Normal activity can cause
the screws to back out of adjustment. DO NOT glob the loctite on, it
can cause damage to the micro switch if you use too much.
2. Begin by adjusting the bottom screw to your desired pull. Screw it in
to lessen the distance the trigger must travel.
3. Very Carefully screw in the top screw. Making large adjustments can
force the screw into the micro switch and damage it. You will want to
screw it in to the point where it makes contact with the micro switch