User's Manual

8
Firing the B2K
Keep your finger out of the trigger guard and away from the trigger; point the
muzzle of your gun in a safe direction at all times during this process. Be sure your
goggles are securely in place. Push the on-off switch into the off position.
Always keep your B2K pointed in a safe direction!
1. Place the empty loader onto the gun. Be sure that it is securely mounted in
place.
2. Apply the compressed gas, pressurizing the gun.
3. Put the paintballs into the loader.
4. Remove the barrel plug.
5. Aim the gun at the target.
6. Push the on-off switch to the ON position, the LED will light up.
7. Place your finger on the trigger.
8. Pull the trigger with a smooth squeezing motion. BANG. . . .
UNLOADING THE B2K
Keep your finger out of the trigger guard and away from the trigger; point the
muzzle of your gun in a safe direction during this entire process. Always keep your
B2K pointed in a safe direction!
1. Push the on-off switch to the off position. The LED will be off.
2. Place the barrel plug into the end of the barrel.
3. Remove the pressurized gas from the marker carefully.
4. Tilt the marker so that the loader is lower than the body of the gun.
5. Remove the paintball loader from the direct vertical-feed tube, turning the
loader in a clockwise direction.
6. Inspect the inside of the direct vertical-feed tube to be sure that a ball does not
remain inside the breech.
MAINTENANCE
CAUTION: Before attempting to perform any maintenance operations or any gun
disassembly, make sure that all paint pellets and sources of propellants have been
removed from the gun. Insert a barrel plug, push the on-off switch to the OFF
position and keep the gun in its "SAFE" mode.