User's Manual

OPERATION
Read the entire manual before you prepare your B2K for firing. Safety and safe gun
handling are the most important aspects of paintball sports. Please practice each of
the following steps with an unloaded gun before attempting to charge your gun
with compressed air and paint pellets. Do not load compressed air and paint
pellets into your B2K until you feel completely confident with your ability to
handle your B2K safely.
Keep your finger out of the trigger guard and away from the trigger; point the
muzzle of the gun in a safe direction at all times. Keep the gun turned off until
ready to operate. The B2K does not have a mechanical safety, only an on-off
switch! Always keep your B2K pointed in a safe direction. Always use a barrel
plug.
Installing the 9 volt Power Source
The B2K requires a single 9-volt battery as the electronic power source. The use of
long life batteries is recommended.
The 9-volt battery is located in the frame (or Αtray≅) above the trigger and on-off
switch. The battery is accessed through a battery cover located on the right side of
the gun.
Remove the 2 screws that hold the battery cover in place. Connect the battery to
the terminal and place the battery inside the frame (or tray) carefully being sure that
the black and red wires to the terminal are forward and are toward the bottom.
Make sure that there are no abrupt kinks and the wires are comfortably placed, do
not force them into place. Replace the cover and 2 screws.
If you need to remove the complete battery frame and grip follow these
4