User's Manual

8
The B2K2 features 8 different modes of fire.
Mode selection is dependant on the switch settings of the DIP switches on the
Printed Circuit Board.
Modes are:
1. Semi-auto (one single shot per trigger pull),
2. 2 shot (2 shots if the trigger is pulled and not released, with single shot
capabilities)
3. 3 shot burst (3 shots if the trigger is pulled and not released, with single
shot capabilities)
4. 6 shot burst (6 shots if the trigger is pulled and not released, with single
shot or any amount between capabilities).
5. Auto Response mode fires once the trigger is pulled and once when it is
released.
6. Turbo mode (emulated trigger reaction). To engage this mode you must
maintain a sequence of cycles within a pre-determined timing
rate, and as long as this repetition is maintained, the mode will
remain engaged.
7. Zip mode (a ramping cycle) starts at 8 BPS and increases to 12 BPS
within a 6 shot burst if the trigger is pulled and not released, with
single shot or any amount between capabilities.
8. Full auto (as long as the trigger is pulled it will cycle).