User's Manual

18
b. As you run and shoot, you actually unweigh the gravity-fed balls in
your loader. This can cause a ball to hesitate in its drop. This affects
your trigger timing.
c. If the ball retention ball does not move freely, the paintballs will
crush against it or it may have stuck in the depressed position allowing
double feeding. Check its tension regularly and keep this area as clean as
possible.
d. If the ball retention ball is too sloppy, the ball will not be held in the
proper position. This may allow the next ball to enter the path of the
bolt, subjecting it to impact cracking or shearing. Verify the tension.
e. Increasing the timing of the solenoid on time will decrease the possible
blow- back that is created when the ball is expelled, or increasing the
solenoid off time to increase the time that the bolt stays back to let another ball
drop into the breech.
Regulator Related Problems
1. The gauge reads correctly when charged, but climbs in pressure after a
few moments.
a. The regulator seal has been contaminated. Disassemble the regulator, and
clean the seal with a ΑQ-tip≅ and alcohol. If you need assistance in the
Disassembly of the regulator, please call [phone].
2. The gauge reads correctly when charged, but drops in pressure after a few
shots.
a. The regulator may not be adjusted correctly. Remove all pressurized gas,
and back off the regulator adjustment screw 3 turns. Pressurize the system and
adjust the pressure back up to the desired pressure.
3. The gauge reads correctly when charged, but drops in pressure after a few
shots, and is slow to climb back to normal pressure.
a. The recovery side of the regulator is sluggish and may need cleaning and
lubrication. If you need assistance in the disassembly of the regulator, please
call [phone].
b. The regulator seal needs to be replaced if it has a deep groove in it from the
regulator cup.