User's Manual

17
Leak Related Problems
1. The B2K2 has a leak down the barrel. Reason: gas is leaking through or
around the valve pin seal or O>ring area.
a. Can you hear the leak when the gas is removed? Yes? There is no
leak. You hear the ocean.
b. The valve seal is marred/scratched or worn out or dirt has
gotten to it. Replace it.
2. The B2K2 has a leak around the high pressure regulator seam.
Reason: the seal between the regulator body and the main
body is bad.
a. Tighten the regulator to the body.
b. Check and/or replace the O’ring.
3. The B2K2 has a leak around the low pressure regulator seam. Reason: the
seal between the regulator body and main body is bad or the regulator has
loosened up.
a. Tighten the regulator into the body.
b. Check and/or replace the O=ring gasket. Sized -019.
4. The B2K2 has a leak inside the grip/battery area.
Reason: the 4-way valve is leaking.
a. Tighten the 4-way valve to the manifold. Take care not to over-tighten.
b. Check for over-pressurization from the low pressure regulator. Re-adjust
the low pressure regulator.
c. Replace the O=rings on the cylinder assembly. Sized -015.
d. Replace the piston O=ring. Sized -011
e. Replace the solenoid/valve assembly.
Ball Breakage Problems
1. The ball breaks in the breech.
a. The balls in your loader can bind, messing up your trigger timing.
Note the ball drop and use an agitated loader.