User's Manual

take a Αclearing≅ shot before the change in the decreasing direction can be

registered.

A pressure gauge has been installed into the regulator body to indicate the exact

operating pressure of the marker. This gauge is extremely useful. At the factory we

set the regulator gauge to 225-300 PSI with an input pressure of 400 PSI using

Compressed air as the base propellant. Under normal circumstances these settings

will produce paintball velocities at approximately 280-300 fps. The input pressure

from your tank should be set at 350-500 PSI.

Higher input pressures will not

provide increased performance. There is a specific input side and output side of the

main input regulator. If the gauge and input sides are switched, the outcome will be

total bypassing of the main input regulator.

Low pressure regulator adjustment:

The low pressure regulator is externally adjustable via the adjustment screw with

the slot for a wide screwdriver or even a quarter in the front of the low-pressure

regulator. The low pressure regulator is pre-set at the factory to 85-95 PSI to

operate the 4-way solenoid actuated valve. It may be necessary to re-adjust the low

pressure regulator from time to time. Bench adjusting the regulator can be done by

pressurizing the gun, be sure the input regulator is set properly, and then turning the

adjustment screw inward (clock-wise) until you hear a leak coming from the 4-way

valve in the grip area. The 4-way valve has an over-pressurization relief valve that

will start to bleed off at approximately 125 PSI, once you hear the leak start then

back off the adjustment screw 2 turn and the leak will stop. That will approximate

the pressure to about 90 PSI. The low pressure regulator is designed to shut down

and preserve the integrity of the low pressure system if it sees an input pressure

over approximately 400 PSI coming from the main input regulator.

This gun was designed with safety and safety standards in mind. If you attempt to

shoot paintballs higher than established safety standards, the gun will not function

properly.

NOTE 1. You may notice that if you attempt to operate the gun at

extremely high velocities, the internals will not function properly!

NOTE 2. This gun is not designed to shoot above the safety limits

established by industry standards.