User's Manual

Unscrew the barrel with approximately one and one half (1-1/2) revolutions to

remove the barrel for swabbing/cleaning. Keep the barrel clean to insure the

continued accuracy of the B2K2. Gelatin from the paintballs has a tendency to

build up in the barrel. As part of your cleaning ritual, wash out the barrel with hot

soapy water and rinse it well.

Removing the Bolt Assembly (Field Stripping)

Remove the paint and pressurized gas from the gun. The gun can be field stripped

while it is pressurized.

1. Remove (pull) the knurled pin from the top of the marker. Pull the bolt body

out the back of the main body.

Once the bolt assembly is removed, it is possible to clean the entire upper receiver

of the gun, including the breech and feed tube area. You may slightly lubricate the

rear section of the bolt and bolt chamber with a light synthetic spray lubricant

before re-installing the bolt. Do not use petroleum/oil-based lubricants; do use

Teflon or silicon-based lubricants. The Αbolt≅ is NOT a simple plastic; it is a

natural Delrin acetate material, which is a Dupont 3M material, developed

specifically for this type of application. The use of a metal type of bolt will void all

warranties.

1. Point the barrel downward and slide the bolt in until the link pin hole lines up

with the slot in the hammer and carefully install the link pin. Note: You must be

sure that the link pin is engaged PROPERLY with the hammer, if the link pin IS

NOT PROPERLY replaced, you may damage the hammer/cylinder assembly.