User's Manual

11
3. Put the paintballs into the loader.
4. Remove the barrel plug.
5. Aim the gun at the target.
6. Push the on-off switch to the ON position, the LED will light up.
7. Place your finger on the trigger.
8. Pull the trigger with a smooth squeezing motion. BANG. . . .
UNLOADING THE B2K2
Keep your finger out of the trigger guard and away from the trigger; point the
muzzle of your gun in a safe direction during this entire process. Always keep your
B2K2 pointed in a safe direction!
1. Push the on-off switch to the off position. The LED will be off.
2. Place the barrel plug into the end of the barrel.
3. Remove the pressurized gas from the marker carefully.
4. Tilt the marker so that the loader is lower than the body of the gun.
5. Remove the paintball loader from the direct vertical-feed tube, turning the
loader in a clockwise direction.
6. Inspect the inside of the direct vertical-feed tube to be sure that a ball does not
remain inside the breech.
MAINTENANCE
CAUTION: Before attempting to perform any maintenance operations or any gun
disassembly, make sure that all paint pellets and sources of propellants have been
removed from the gun. Insert a barrel plug, push the on-off switch to the OFF
position and keep the gun in its "SAFE" mode.
Simple Maintenance
Keep your B2K2 clean and lubricated to eliminate the friction that would prevent
reliable operation. Clean and lube the gun before each use, and do not put it away
dirty. USE NO OILS! Do not use petroleum-based lubricants in the lubrication of
this gun. Teflon or silicon spray lubricants are the recommended types of
lubrication for the bolt area of the main housing. Lithium grease is recommended
for lubricating the regulator pistons, and the cylinder assembly. Be sure it is
Lithium Grease and not axel grease.
Cleaning Paint from the Barrel